The physical principle of a glass cleaning machine is that after the transducer converts high-frequency electrical energy into mechanical energy, it will generate high-frequency vibrations with extremely small amplitudes and propagate them to the solution in the cleaning tank. Under the action of the transducer, a large number of small bubbles will continuously be generated inside the cleaning solution and burst instantly. The rupture of each bubble will generate several hundred degrees of high temperature and nearly a thousand atmospheres of shock wave, thus washing the workpiece clean.

The emergence of glass cleaning machines has provided convenience for specialized equipment for cleaning and drying the surface of glass in deep processing processes such as mirror making, vacuum coating, tempering, hot bending, and hollow glass lamination.

Glass cleaning machine

So what should we pay attention to when using a glass cleaning machine?

1. Since the glass cleaning machine is operated by a button, it is important to turn on the blower first and then the heater. Turn off the heater first, then turn off the blower. We must not forget this order.

2. When stopping the motor of the glass cleaning machine, it is necessary to reset the speed regulator to zero, or unnecessary trouble may occur.

3. The glass discharge of the glass cleaning machine is regular and must be within the specified limit.

4. There is an emergency stop button on the motor of the glass cleaning machine, which can be used in emergency situations. Do not touch it normally.

5. When the thickness of the glass plate changes in the glass cleaning machine, it is necessary to adjust the height of the air knife in a timely manner for the second-hand glass double-sided machine, or it may cause unnecessary damage accidents.

6. When entering the glass cleaning machine, the water level should be controlled between 200-250mm, and water should not be added at high or low levels.

Regular lubrication of cleaning machines

In order to prevent gear necrosis caused by excessive wear of the wear machine, the cleaning machine must be properly lubricated. The glass coating process requires a very high level of cleanliness for the glass. Dewey's second-hand glass double-sided machine does not allow a small amount of lubricating oil to enter the cleaning area, so it is recommended to choose grease with good mechanical stability and adhesion. Focus on lubrication of the transmission chain, helical gears, and transmission shaft.

1. Use plastic cloth to isolate the parts that need lubrication from the cleaning area to avoid grease contamination.

2. Lubricate the joint surface between the chain, gears, transmission shaft chain rollers, and chain plates.

3. The transmission chain and roller table should be lubricated evenly.

4. Use a clean cotton cloth to wipe off excess lubricating grease.